Patterson-Kelley MACH C1500, Инструкция по установке и эксплуатации

Страница: 5 / 51

MACH® Series Gas-Fired Boiler Installation
Page 1
1.0 INTRODUCTION
The P-K MACH® C1500/C2000
Gas-Fired Boilers are
fully modulating using a variable speed combustion
blower, sophisticated microprocessor controls,
modulating gas safety shut off / control valves and a
unique aluminum alloy heat exchanger capable of
operating in a fully condensing mode to provide
maximum efficiency in a minimum amount of space.
The high-quality materials and thoroughly tested
design of the boiler should provide years of trouble-
free service if the instructions in this manual are
followed carefully.
This manual covers installation of P-K MACH
C1500/C2000 Boilers. The model numbers may be
followed by a prefix or suffix letter in some cases to
indicate special features or different options.
While details may differ slightly, basic operation is the
same for all models. Check the rating plate for correct
fuel usage and gas pressures.
The boiler is only a part of the complete heating
system. This boiler may be fully operational and yet
because of poor circulation, control, or other operating
characteristics, not deliver heat to the desired location.
Additional equipment such as temperature sensors,
pumps, flow switches, balancing valves, and check
valves will be required for satisfactory operation of
any system. Patterson-Kelley cannot be responsible
for the design or operation of such systems and a
qualified engineer or contractor must be consulted.
2.0 SAFETY
2.1 G
ENERAL
The MACH C1500/C2000 gas-fired boiler must be:
•
Installed, operated, and serviced in accordance
with instructions contained in this manual.
•
Installed by qualified personnel in accordance with
designs prepared by qualified facility engineers
including: structural, mechanical, electrical, and
other applicable disciplines.
•
Operated and serviced in accordance with a
comprehensive safety program determined and
established
by the customer . Do not attempt to
operate or service until such a program has been
established.
•
Operated and serviced by qualified and
knowledgeable personnel in accordance with all
applicable codes, laws, and regulations.
•
The use of the term “factory-trained personnel”
throughout this manual indicates Patterson-
Kelley trained on this specific piece of
equipment.
Note : Each safety device must be maintained and
checked per the recommended schedule; refer to
Section 5.1 of this manual.
2.2 T
RAINING
It is
essential to read, understand, and follow the
recommendations of this manual before installing,
operating, or servicing this equipment. Failure to do
so could result in fire or explosion and serious injury,
death, and/or property damage.
Proper training is the best protection against
accidents. Operating and service personnel must be
thoroughly familiar with the basic construction of the
P-K MACH C1500/C2000
boiler, the use and
locations of the controls, the operation of the boiler,
adjustment of its various mechanisms, and all
applicable safety precautions. If any of the
provisions of this manual are not fully and completely
understood, contact the Patterson-Kelley Sales
Department toll-free at (877) 728-5351 for assistance.