Patterson-Kelley MACH C1500, Инструкция по установке и эксплуатации

Страница: 38 / 51

MACH® Series Gas-Fired Boiler Maintenance
Page 34
5.5.1 Manual Reset Service Codes
Code Lockout Description
E 00 False flame. A flame signal is present when it shouldn’t be.
E 02 Flame failure. The burner did not light on startup, or loss of flame during run or high temp limit tripped.
E 03 Gas Valve Relay Board error. Electrical connection from control to GVRB open.
E 04 General lockout. The power was lost after a lockout. The control loses the description of the lockout on
power loss.
E 08 Air pressure switch open. The air pressure switch is open. Insufficient air flow.
E 12 Limit open. High & Low Gas Pressure, Low water cut off(s). Optional External limit
E 18 Outlet high temp. The outlet water temperature has exceeded the internal high temperature setting.
E 19 Inlet high temp. The inlet water temperature has exceeded the internal high temperature setting.
E 25 Outlet temp rapid change. The outlet water temperature is increasing too fast. Indicates low flow condition.
E 28 No blower feedback. The blower should be running but it is not, or the feedback signal has been interrupted.
E 29 Blower feedback will not zero. The blower will not go to zero speed even though it should be off.
E 31 Outlet sensor shorted. The outlet temperature sensor is short circuited.
E 32 Inlet sensor shorted. The inlet temperature sensor is short circuited.
E 33 DHW sensor shorted. The Domestic Hot Water temperature sensor is short circuited.
E 35 Flue sensor shorted. The flue gas temperature sensor is short circuited.
E 36 Outlet sensor open. The outlet temperature sensor is indicating an open circuit.
E 37 Inlet sensor open. The inlet temperature sensor is indicating an open circuit.
E 38 DHW sensor open. The Domestic Hot Water sensor is indicating an open circuit.
E 40 Flue sensor open. The flue gas temperature sensor is indicating an open circuit.
E 52 High flue temp. The flue temperature has exceeded the maximum allowable setting.
Note : This list is not inclusive of all possible codes. If any other error codes are displayed on the boiler, call a
qualified and knowledgeable service agency.