![background image](http://html1.mh-extra.com/html/paslode/cf325im/cf325im_operating-manual_3922341017.webp)
17
Servicing
Air Filter
Open the grille by pressing slightly above the adapter, and
pivoting the cover open. The air filter simply lifts out.
Tap the filter GENTLY to remove any dust. Check and clean
the air filter every two days. Soap and water restores the
filter to a "like new" condition.
End-of-Workday Routine
At the end of each workday, conduct an end-of-workday
routine. These simple steps are based on maintaining the
safety and operational efficiency of the Paslode Cordless
Framing Nailer.
Before you leave the work site:
1. Remove battery and store in tool case. Always use the
Cordless Framing Nailer case for transporting and
storing the tool.
2. Dispose of all empty fuel cells. Remember to
dispose of these cartridges where they will not be found
by children, crushed, punctured, or burned.
When you get home:
1. Place the battery in its charger if it needs charging as
indicated by the red charge light on the handle.
2. Wipe your Cordless Framing Nailer with a clean, soft
cloth.
3. Remove and clean the filter every two days.
Cordless Framing Nailer Paslode
Cordless Tool Accessories
A variety of accessories are available for the Paslode
Cordless Framing Nailer:
No-Mar Work Contacting Element
USA Part No. 901252
Au and NZ Part No. B20544G
Battery
USA Part No. 902654
Au and NZ Part No. B20543A
Clear Safety Glasses
USA Part No. 401382
Paslode Lubricating Oil
USA Part No. 401482
Au and NZ Part No. B20544F
Battery Charger
USA Part No. 902667
Au and NZ Part No. B20543B
Paslode Cordless Framing Nailer Case
USA Part No. 905607
Contact your Paslode
®
representative for additional
information.
Tools
A 5/32 Hex Socket Wrench (Part No. 401331) is provided
with each Paslode Cordless framer.
WARNING
Make certain magazine mounting screws are tight and
magazine is tight to nose. Attempting to fire tool with a
loose magazine will result in loss of nail control,
damage to tool, or nail discharge toward operator.
Tool Cleaning and Oiling
Periodic cleaning and oiling are necessary to keep the
Paslode Cordless Nailer operating properly. The tool
should be cleaned and lubricated at least every 50,000
cycles. This number may vary depending upon the rate at
which the tool is used and the operating conditions it is
used in. The chart in the cleaning instructions will help you
determine how often the tool should be cleaned.
Grille
Filter