C. Installing Drivers
Put sealing caulk around all drivers prior to mounting. When applying caulk to the tweeters, it is a good
idea to first roll the caulk between your fingers to “thin out” the caulk bead. Having too much caulk on the
tweeters mounting flange may not allow the faceplate to mount flush with the baffle. All driver openings
have been predrilled for the mounting screws. Make sure that you align the driver mounting holes with
the predrilled holes.
Left/Center/Right: Remove excess wire and then strip and tin the wire ends. Solder each wire to the
appropriate driver terminals while observing proper polarity (positive to positive, negative to negative). The
Audax woofers have red paint on the positive terminal. Be careful not to apply too much heat to the driver
terminals especially the tweeters. Install the drivers using the #8 (large) screws for the woofers and the #6
(small) screws for the tweeters. Tighten the screws only until the driver is flush with the baffle of the cabinet.
Do not over tighten the screws!
Page 8
