Pars ABL GIANT 3.0, Руководство пользователя

Страница: 53 / 57

TROUBLESHOOTING
The troubleshooting section in this book is a guide, do not hesitate to contact your
ABL service partner if you need assistance
ERROR DESCRIPTION PROBABLE CAUSE SOLUTION
High hydraulic oil temp
Low oil level
Hydraulic Component failure
Clogged hydraulic filter
Clogged oil cooler
Add hydraulic oil
Replace the component
Change filter
Clean with compressed air
Garbage stripes behind machine Too small side brushes Replace side brushes
Garbage stripes behind machine
To small centre brush Replace centre brush
Garbage stripes behind machine Collector shoe rubber too small Replace rubber
Garbage stripes behind machine Collector shoe doesn’t seal against
centre brush
Tighten against the centre
brush
Garbage stripes behind machine
Lower elevator rubber broken Replace elevator rubber
Side brush throws the debris back
to the curb stone
The side brush is to flat against the
ground
Increase the side angle of
the side brush
Sweeping does not start Something is stuck in the elevator Drive the elevator and
centre brush backwards
Sweeping does not start
Low oil level Add hydraulic oil
Sweeping does not start Emergency stop Release emergency stop
Sweeping does not start Electrical fault Look into the wiring
diagram
No water from the water bar Clogged water nozzles Clean nozzles
No water from the water bar Clogged water filter Clean water filter
No water from the water bar
Water pump broken Replace water pump
Diesel engine stops
No fuel in diesel tank Add diesel
Diesel engine stops Fuel filter clogged Replace fuel filter
Diesel engine stops Too high engine temp Check cooler
Diesel engine stops
Too low oil temp Add oil
53