LUBRICATION MAINTENANCE INTERVAL SCHEDULE
DIESEL ENGINE MAINTENANCE AFTER FIRST 50 HOUR
THIS PROCEDURE SHOULD BE DONE EVERY 500 HOURS INTERVAL
Replace oil and oil filter
-
Remove motor hood
-
Place a bucket under the drain plug (
1
)
-
Warm up the engine 10 minutes so that the engine oil gets hot before changing the
oil filter
-
Turn off the engine, turn of the main switch
-
Remove the drain plug (
1
) in the oil pan (
3
), drain engine from oil
-
Remove the Cap (
4
) from filter body (
7
)
-
Filter element (
6
) will be attached to cap (
4
) Remove filter element (
6
) from cap (
4
)
-
Discard old filter element
-
Remove O ring seal (
5
) from cap (
4
) discard O ring seal
-
Ensure the cap and filter body are clean and free from dirt or damage, inspect new
filter element for damage before installing
-
Install new O ring seal (
5
) onto cap (
4
) Install new filter element (
6
) into cap (
4
) install
new filter element (
6
) and cap (
4
) to filter body (
7
)
-
Fill the oil through the oil filler cap (
8
) allow the oil to drain down to the oil pan for a
minimum 30 minutes before starting the engine
-
Turn on the main switch, turn on the engine and allow the engine to idle for 2
minutes to check for any leaks
-
Turn off engine wait 30 minutes, check oil level on dipstick if
it’s to low fill up
with oil
The engine requires a total of 8-10 liter, SAE 15W-40 oil
28
Содержание ABL GIANT 3.0
