INSTRUCTION REF: IN205
ISSUE NO. 3
DATE 07.03.12
Page 4 of 18
www.parry.co.uk
4
6. Pressure test point is located underneath the appliance
– it is located on the
tap rail.
7. Low rate is factory set for LPG gas, and only require adjustment when
converting from LPG to NAT Gases.
8. Remove all protective film before use.
9. Ensure whoever is operating the appliance is fully conversant with its
operation and aware of dangers involved in incorrect operation and cleaning,
especially the danger of burns and scolds from the cooking medium and hot
surfaces of working areas.
The appliance must be placed in a well ventilated location,
underneath a suction fan with a suction capacity of at least 1500m3/h
The griddle must be secured by placing four M10 sized screws with
at least 15mm of thread available.
In the shape of a rectangle, holes should be drilled on the work
surface for the location of where the feet will sit
Screws will be placed through the work surface so the feet of the
appliance can sit directly on top of the screws so appliance can not
move
Sizes required : GGP6.4 295mm x 332mm
Sizes required : GGP6.6 295mm x 532mm
Sizes required : GGP6.8 295mm x 732mm
Sizes required : GGP6.10 295mm x 932mm
