Parrot ANAFI USA, Руководство пользователя

Страница: 39 / 106

User Guide v6.7.7GOV – © Parrot, April 29, 2022 39
Battery care and safety
As you can see,
ANAFI USA
’s smart LiPo battery is as high-tech as any other element of
your drone. It even features a wintering mode, designed to increase its durability and
facilitate its care. Ideally, when not in use for a prolonged period, batteries should be stored
half-charged. When not in use for 10 days,
ANAFI USA
’s smart battery discharges itself, if
required, to 65% charge, over a 48h period. In other words, after a maximum of 12 days
without use, this smart battery enters hibernation with a charge level which never exceeds
65%. If you leave your
ANAFI USA
battery for 12 days, you will find out its power button does
not activate the charge level LED indicators. The battery needs to be charged to exit the
wintering mode and start operating as described in the earlier paragraphs: this behavior
preserves the battery over time. Parrot recommends you always run a full charge of your
smart battery before flying
ANAFI USA
.
Like all other LiPo batteries,
ANAFI USA
’s smart battery must be handled, transported and
stored with care:
-
never leave a battery unattended while charging;
-
never expose a battery to extreme temperatures, neither hot, nor cold;
-
never charge a battery which is still warm from use (wait for at least 20 minutes);
-
never use or recharge a damaged or swollen battery;
-
always store your battery in a dry, ventilated place, at a temperature close to 20°C;
-
always carry your battery in a fire-retardant bag or case (unless it is installed on
ANAFI USA
: it can then be transported with the drone, inside its carrying case).
Finally, note that
ANAFI USA
’s smart battery will only allow charge in ambient temperatures
b10°C and +45°C, and that using
ANAFI USA
in temperatures approaching -10°C will
reduce its flying time. To minimize this slight drop in the smart battery’s capacity, keep your
battery as warm as possible before starting a flight in a cold environment.
If the behavior of your battery is not consistent with the elements contained in this
section, and if you cannot get it to power your
ANAFI USA
, you must hard reset your
battery: plug it to a power source with the enclosed cable, then keep the battery’s
power button pressed for 15 seconds (regardless of the behavior of the LEDs), and
release the button.
The battery’s LEDs flash quickly, one after the other, alternating green and red: the
hard reset is successful!