9
Installation
Electrical connection
Appliances with three-pole cable are set up for operation with single phase alternating
current at the voltage and frequency indicated on the rating plate (220-240V/50Hz).
The connection to the electricity supply must be made by a qualified person and
following the regulations in force.
The connection cable must be secured in a strain-relief clamp.
The electric supply of the hob must have an isolation switch
which enables you to disconnect it in case of an emergency or
maintenance.
When the appliance is to be installed above a built-in oven, the two appliances must be
connected separately, to make it easier to take the appliances out and for electrical
safety. The supply cable must be positioned so that no point can reach a temperature of
50°C higher than the ambient temperature. Check that the supply system has an
effective earth connection and corresponds to the standards in force. Also ensure and
that the plug can be reached easily when the appliance is installed.
The green/yellow Earth wire must be connected to the Earth terminal marked
with
The brown Live wire must be connected to the Live terminal marked with L.
The blue Neutral wire must be connected to the terminal marked with N.
Always place the wire on the side of the screw in the tightening direction
(clockwise).
The manufacturer refuses all responsibility if the standards in force are not adhered
to.
