17
18
Aileron: 10mm up, 7mm down measured at widest point +/– 1mm
Elevator: 10mm up, 10mm down measured at widest point +/– 1mm
Rudder: 12mm left, 12mm right measured at widest point +/– 2mm
CG Range: 29mm–31mm from leading edge of wing at the fuselage
Note: After initial flights, the CG can be adjusted to the pilots preference.
Stock Control Throw
• If the blinking red status LED keeps flashing, you do not have a
positive RF link between the transmitter and receiver. Check to be sure
that the transmitter has been powered on and that the LED indicator
on the transmitter is glowing solid red. If the transmitter is powered on
and functioning properly, disconnect the flight battery from the receiver
unit, then reconnect it. Now the receiver unit should initialize and arm
properly.
Note: In the event you inadvertently enter Bind Mode, the LED on the
AR6400 will be flashing red continuously. If this occurs, cycle the
flight battery while the transmitter is on (if previously bound). If your
receiver unit will not initialize and arm after following the guidelines
as listed above, call the Horizon Support Team at 1-877-504-0233.
• Once you have placed the airplane in a safe area, free of obstructions,
and are clear of the propeller, you can safely begin to power up the
model to check for proper operation of the motor.
• Advance the throttle stick upward slowly, just until the propeller begins
to spin.
DO NOT attempt to fly the airplane at this time.
Note the
direction the propeller spins. If viewed from the front of the airplane the
propeller will spin counterclockwise. If it is spinning backwards,
disconnect the battery and reverse the polarity of the motor’s input
power leads.
