Parkside PVKO 50 B2, Руководство по эксплуатации и технике безопасности

Страница: 28 / 36

23 GB
Then close the drain screw (5) again (turn clockwise). Check
the pressure vessel (3) for rust and damage each time before
use.
The compressor shall not be operated if the pressure vessel (3)
is damaged or rusty. If you discover damage, please contact
the customer service workshop.
The condensate from the pressure vessel may contain oil resi-
due. Dispose of the condensate in an environmentally-friendly
way at the appropriate collection point.
13.3 Safety valve (Fig. 1/6)
The safety valve (7) is set to the maximum permissible pressure
of the pressure vessel (3). It is not permitted to adjust the safety
valve (7) or to remove the connection lock (7.2) between the
drain nut (7.1) and its cap (7.3).
In order for the safety valve (7) to function properly when need-
ed, it must be actuated every 30 operating hours and at least
3 times a year.
Turn the drain nut (7.1) anti-clockwise to open the safety valve
(7) drain.
The safety valve (7) now audibly lets out air. Then turn the drain
nut (7.1) clockwise again to tighten.
13.4 Storage
m Attention!
Disconnect the mains plug, vent the device and all
connected compressed air tools. Store the com-
pressor in such a way that it cannot be used by un-
authorised persons.
m Attention!
Store the compressor only in dry locations that are
inaccessible for unauthorised persons. Do not tilt
the unit, only store it upright!
13.4.1 Releasing overpressure
Release overpressure in the compressor by switching off the
compressor and using up the compressed air still in the pres-
sure vessel (3), e.g. with a compressed air tool running at idle
or with an air blow gun.
13.5 Transport (Fig. 1)
The compressor can be tilted it up by means of the transport
handle (1) so that it can be transported on the wheels (4).
13.6 Ordering spare parts
Please provide the following information when ordering spare
parts;
• Device type
• Device article number
13.7 Service information
With this product, it is necessary to note that the following parts
are subject to natural or usage-related wear, or that the follow-
ing parts are required as consumables.
Wearing parts*: Clutch
* may not be included in the scope of supply!
14. Disposal and recycling
The device is supplied in packaging to avoid transport dam-
ages. This packaging is raw material and can thus be used
again or can be reintegrated into the raw material cycle.
The device and its accessories are made of different materials,
such as metal and plastic. Take defective components to spe-
cial waste disposal sites. Check with your specialist dealer or
municipal administration!
The packaging is made of environmentally friend-
ly materials that can be disposed of at your local
recycling centre.
You can find out how to dispose of the disused de-
vice from your local authority or city administra-
tion.
Do not throw old equipment away with household
waste!
This symbol indicates that this product must not be dis-
posed of in household waste as per Waste Electrical
and Electronic Equipment directive (2012/19/EU) and
national laws. This product must be handed over at the
intended collection point. This can be done, for example, by
returning it when purchasing a similar product or delivering it to
an authorised collection point for the recycling of old electrical
and electronic devices. Improper handling of old devices can
have negative effects on the environment and on human health
due to potential hazardous materials which are often con-
tained in old electrical and electronic devices. By disposing of
this product properly, you are also contributing to the effective
use of natural resources. Information about collection points for
old devices can be found at your municipal authority, the local
disposal provider, an authorised location for the disposal of old
electrical and electronic devices or your waste collection ser-
vice.