Parkside PISG 80 A3, Перевод оригинальной инструкции по эксплуатации и безопасности

Страница: 9 / 40

9 GB/IE/NI
„
Do not weld atop containers,
receptacles or pipes, which
do or did contain flammable
liquids or gasses.
WARNING Avoid any direct
contact with the welding
circuit. The no-load voltage
between the electrode holder
and earth terminal can be dan-
gerous, there is a risk of elec-
tric shock.
„
Do not store or use the equip-
ment in a moist or wet environ-
ment or in the rain. The Protec-
tion Provision IP21S applies in
this respect.
„
Protect the eyes with the ap-
propriate safety glass (DIN
Grad 9-10) to be installed in
the included welding shield.
Use gloves and dry protec-
tive clothing free from oil and
grease to protect the skin from
ultraviolet rays and the arc.
WARNING Do not use the
welding power source to thaw
pipes.
Remember:
„
The arc ray can damage the
eyes and cause burns to the
skin.
„
Arc welding produces sparks
and drops of molten metal, the
welded work piece begins to
glow and remains very hot for
a relatively long time. There-
fore do not touch the work
piece with bare hands.
„
Arc welding releases noxious
fumes. Be careful not to inhale
these as best possible.
„
Protect yourself from the danger-
ous effects of the arc and keep
persons not involved in the work
at least 2 m away from the arc.
ATTENTION!
„
Depending on mains condi-
tions at the connection point,
operating the welding equip-
ment may interfere with the
voltage supply for other loads.
When in doubt, please contact
your power supply company.
„
Operating the welding equip-
ment may interfere with the
functionality of other devices,
e.g. hearing aids, pacemak-
ers, etc.
z
Safety hazards
during arc welding
Arc welding produces a variety
of safety hazards. It is therefore
particularly important for the
welder to observe the following
rules to avoid putting himself and
others in danger and to prevent
damage to persons and the
equipment.
Safety instructions