Parkside PISG 80 A3, Перевод оригинальной инструкции по эксплуатации и безопасности

Страница: 14 / 40

14 GB/IE/NI
z
Start up
Note:
The welding tool is suitable for weld-
ing with electrodes.
„
Use electrode retaining clips without pro-
truding retaining screws meeting today‘s
safety standards.
„
Be sure the ON / OFF switch 9 is set to
position “O“ (“OFF“) or the main supply
cable
10
is not plugged into the mains
socket.
„
Connect the welding cables according
to polarity and electrode manufacturer
instructions.
„
To do so, connect the port of the earth
terminal
4
(black) with the appropriate
outlet on the inverter welding machine
(black, marked with “-”).
„
Connect the port of the electrode holder
5
(red) with the appropriate outlet on
the inverter welding device (red, marked
with “+”),
„
Put on suitable protective clothing
according to provisions and prepare the
work area.
„
Connect the earth terminal 4 to the
workpiece.
„
Secure the electrode in the electrode
holder
5
.
„
Switch on the device by setting the ON /
OFF switch 9 to the “I“ (“ON“) position.
„
Set the welding current with the control
knob
3
according to the electrode used.
Note: Please see the table below for the
welding current according to electrode
diameter.
Ø Electrode welding current
1.6 40 – 55 A
2.0 55 – 65 A
2.5 65 – 80 A
Attention:
Do not bring the earth
terminal 4 and the electrode holder 5 /
electrodes into direct contact with one
another.
Attention: When welding with elec-
trodes (MMA - manual metal arc
welding) the electrode holder 5 and the
earth terminal 4 lug must be connected
to positive (+) or negative (-) according
to the welding rod specifications.
„
Hold the welding shield 7 in front of
your face and begin welding.
„
To stop working, set the ON / OFF
switch 9 to the “O“ (“OFF“) position.
ATTENTION!
When the thermal overload protection is
triggered, the yellow control lamp
2
lights
up. In this case, no further welding is
possible. The device is still in operation for
the fan to cool the device. As soon as the
device is ready for use again, the yellow
control lamp
2
switches off automatically.
The welding function is now given again.
ATTENTION!
Be careful not to rub the welding rod against
the workpiece. This could damage the
workpiece and make it difficult to strike an
arc. Maintain the proper distance to the
workpiece after striking the arc. The distance
should correlate to the diameter of the
welding rod used. Maintain this distance as
accurately and consistently as possible whilst
welding. The angle between the welding
rod and the working direction should be
between 20 and 30 °.
Start up