Parkside PDSS 400 A1, Инструкции по эксплуатации и безопасности

Страница: 9 / 97

9 GB
Safety instructions for air tools
applications for which it was
designed!
„ „
Do not overburden the device.
„ „
Never use hydrogen,
oxygen, carbon dioxide
or other bottled gasses to
power this tool as doing so
may result in explosion, thus
severe injuries.
„ „
Regularly maintain and clean
the device as required (see
chapters „Maintenance“ and
Cleaning and care“).
„ „
Check the device for damage
prior to initial operation. Al-
ways verify the tool‘s proper
condition before every use.
„ „
Remain alert at all times! Un-
foreseen machine movement
due to reaction forces or the
tool or counter bearing break-
ing may result in injuries.
„ „
Risk of injury due to chips be-
ing projected at high speeds
in the event the tool (socket)
breaks.
„ „
Unforeseen tool movements
may result in hazardous situa-
tions.
„ „
Crushing risk based on the
torque between the counter
bearing and the work piece.
„ „
Keep hands away from the
tool (socket) being used to pre-
vent the risk of injuries.
„ „
Only use holders and adapt-
ers in good condition and
intended for use with the ma-
chines described here.
„ „
Avoid an unnatural posture.
Always maintain a proper
footing and balance. This will
allow you to better control the
electrical power tool in un-
foreseen circumstances.
„ „
Switch the device off when not
in use.
„ „
Always wear personal
protective equipment and
safety glasses. Wearing
personal protective equipment
such as dust mask, non-slip
safety shoes, hard hat or ear
protectors, depending on the
type of air tool and its applica-
tion, reduces the risk of inju-
ries.
„ „
Protect hoses from kinks, con-
strictions, solvents and sharp
edges. Keep hoses away from
heat, oil and rotating parts.
„ „
Replace damaged hoses im-
mediately. A damaged supply
line may result in the air hose
flapping about, possibly result-
ing in injuries.
„ „
Do not use the equipment
when fatigued or under the
influence of drugs, alcohol or
medications. Just a moment of
carelessness when using this
equipment may result in seri-