Parkside PDSS 400 A1, Инструкции по эксплуатации и безопасности

Страница: 16 / 97

16 GB
„ „
In torque controlled machines
with continuous rotation the air
pressure has a safety-related
impact on the output. There-
fore hose length and diameter
requirements must be deter-
mined.
„ „
Never carry pneumatic tools
by the hose.
z
Commissioning
Note: the device is operational after install-
ing the plug nipple
6
.
z
Connecting
Note: only use connection hoses with a
minimum inside diameter of 9 mm.
„ „
First wrap a piece of Teflon tape (not in-
cluded) around the outer threads of the
plug nipple
6
and the lubricator
10
(see
Figure B).
„ „
Now screw the plug nipple
6
into the
thread of the lubricator
10
(see Figure C).
„ „
You must use an open-end spanner (14
mm / 17 mm) to tighten this connection
with moderate force.
„ „
Now turn the combination of lubricator
10
and plug nipple
6
into the connec-
tion thread
2
of the impact driver (see
Fig. C).
„ „
Also retighten this connection with an
open-end spanner (17 mm).
„ „
Now press the air hose onto the plug nip-
ple
6
using a little force, until the hose
locks in.
ATTENTION! Be sure the air hose is
firmly connected. A loose hose
whipping about out of control presents
a major hazard. Also ensure the two
screw connections between lubricator
10
, plug nipple
6
and machine are
securely seated.
z
Inserting the socket wrench
or bit
„ „
ATTENTION! Always install the desired
socket key before connecting the tool to
your compressed air system. Always dis-
connect the compressed air supply from
the compressed air connection
2
before
attaching or changing socket keys
8
.
„ „
Insert the correct socket
8
, if necessary
with extension
5
, in the drive
4
.
„ „
Slide the socket attachment
8
onto the
square 4 of the drive.
„ „
Be sure the snap ring is locked into the
notch of the socket attachment
8
.
„ „
Only use socket attachments sizes ½“
specified in figure A.
„ „
Be sure the socket attachments
8
used
are not damaged. Never use damaged
or the wrong size (not suitable) socket
attachments
8
.
z
Adjusting the compressed
air
Note: this device is designed for an operat-
ing pressure of up to 6.3 bar and a com-
pressor with the minimum air flow specified
in the technical specifications. When setting
the air pressure, remember the pressure
drops by approx. 0.6 bar with a hose length
of 10 m and an inside diameter of 9 mm.
Safety instructions for air tools / Commissioning