Parkside PDLA 6.3 A1, Перевод оригинальной инструкции

Страница: 21 / 77

PDLA 6.3 A1 GB
│
IE
│
17 ■
Refilling oil
To ensure that the appliance remains operational
for a long time, it must have a sufficient supply of
pneumatic oil.
The following options are available
♦ Attach a maintenance unit with an oiler to the
compressor.
♦ Install a fitted oiler into the compressed air line
or the compressor.
♦ Manually add 3–5 drops of pneumatic oil from
the supplied oil container into the connecting
nipple after every 15 minutes of operation.
♦ When opening the oil container for the first
time, remove the cap nut from the container.
Use a pair of long-nosed pliers or a similar
implement to remove the internal pipette.
♦ Turn it 180°, replace it and screw it back in
place with the cap nut.
♦ Use a needle or similar tool to poke a small
hole into the tip of the pipette to release the oil.
Connecting to a compressed air
source
NOTE
► Before connecting the compressed air source,
–
the correct working pressure (3–6 bar)
must be fully reached
–
make sure that the trigger is not
actuated
♦ Pull the supply hose connector over the quick-
release fastener on the connecting nipple
until it clicks into place.
NOTE
►
The compressed air source must be equipped
with a pressure reducer to ensure that you
can regulate the air pressure.
Use
♦ The appliance is ready for use as soon as the
pneumatic air flow has been established.
♦ Guide the punch or the flange tool to
the point of the workpiece to be machined
(see also fold-out page Fig. A + B)
♦ Press the trigger .
CAUTION!
► Suitable safety precautions must be taken
depending on the size and nature of the
workpieces. Use suitable clamping devices
to prevent the workpieces from slipping.
► In the event of an interruption to the air supply,
release the trigger immediately.
► Before switching on the machine, make sure
the machine tool is firmly placed on the
surface to be processed.
♦ When you have finished working, disconnect
the appliance from the compressed air source.