Parkside 361911 2007, Перевод оригинальной инструкции

Страница: 41 / 60

PTSS 1200 C2 ■ 38 │
GB
│
MT
Eccentric screws
The eccentric screws are intended for the
adjustment of the fit of the base plate on the
guide rail .
♦ Tighten the eccentric screws to reduce the
play between the circular saw and the guide
rails .
Sawing (without the guide rail)
Right-angled sawing
♦ Hold the machine with both hands firmly on
the handles and .
♦ Switch on the appliance as described in
"Switching on and off".
♦ Place the appliance with the front part of the
base plate on the workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Mitre angles up to 45°
♦ Adjust the cutting angle as described.
♦ Hold the machine with both hands firmly on
the handles and .
♦ Switch on the appliance as described in
"Switching on and off". Place the appliance with
the front part of the base plate on the work-
piece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Plunge cuts
♦ When making a "plunge cut" that is not at right
angles, secure the base plate of the saw to
prevent any lateral movement. Lateral movement
can cause the saw blade to jam, thus causing a
kickback.
♦ Adjust the desired cutting depth as described
above.
♦ Place the appliance onto the workpiece.
♦ Avoid a kickback and place the rear edge
against a stop.
(reference is made to this in the section "Plunge
cutting using the guide rail").
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on
the handles and and pivot it.
NOTE
► The cutting width marking on the side of
the blade guard shows the front and rear
cutting point of a 165 mm saw blade at
maximum cutting depth. This applies both for
plunge cuts using the guide rail and
plunge cuts without using the guide rail .
Sawing (with the guide rail)
Right-angled sawing with the guide rail
♦ Apply the guide rail with the foam rubber
elements onto the workpiece.
♦ Place the appliance with the groove onto
the guide rail .
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on
the handles and and pivot it.