Parkside 356378 2004, Инструкция по сборке, эксплуатации и безопасности

Страница: 8 / 22

8 GB/IE
Screw the struts to the front legs
4
. To do this, use the washers, nuts and
screws
13
. Tighten the nuts just enough so that the screw joints remain
flexible (see Fig. L and M).
Assemble the cross braces
8
using the washers, nuts and screws
12
.
Tighten the screws
12
(see Fig. N).
Insert the plastic feet
1
so that their grooved surfaces form a level
standing platform (see Fig. O).
Use
Stand the workbench on its legs. Push the joints on the struts down until
they are horizontal and not bent. This gives the workbench stability and it
is ready to use (see Fig. P).
Note on functionality: Turning both crank handles simultaneously
will move the rear clamping plate
9
. During use as a work table, this
allows the size of the table surface to be adjusted. During use as a
clamping table, this allows the workpiece to be clamped (see Fig. Q).
To clamp workpieces:
Insert the clamping jaws
2
in a suitable position in the clamping plates
9
,
10
, (see Fig. R).
Clamping workpieces with parallel surfaces:
Turn the clamping jaws
2
so that their grooved surfaces hold the work-
piece (see Fig. S).
Clamping round workpieces:
Turn the clamping jaws
2
so that their horizontal indentations hold the
work piece (see Fig. T).
Use as a work table:
Remove the clamping jaws
2
. Adjust the clamping plates
9
,
10
to create
a table surface of a suitable size (see Fig. U).
Care
Do not use harsh or abrasive cleaning agents. Allow the workbench to
dry fully before storing it.
Carefully clean the workbench after each use. To do this, use a brush or
a damp cloth.
Grease all moving parts occasionally using a standard lubricating
grease.
Storage
Choose a dry location for storage.
Move the clamping plates
9
,
10
so that they are completely together
(see Fig. V).
Pull the joints of the struts upwards to bend them (see Fig. W).
Push the legs together at the bottom. The table surface will tilt upwards
(see Fig. X).
Push the legs
3
,
4
,
5
, together as far as they will go (see Fig. Y).
The workbench is ready for storage.
Store the workbench lying flat or leaning against a wall in such a way
that it cannot fall over.
Disposal
The packaging is made entirely of recyclable materials, which you may
dispose of at local recycling facilities.
Contact your local refuse disposal authority for more details of how to
dispose of your worn-out product.
Service
Conmetall Meister GmbH
Oberkamper Straße 39
42349 Wuppertal
GERMANY
Email: meister-service@conmetallmeister.de