Parkside 298505, Инструкции по эксплуатации и безопасности

Страница: 10 / 57

10 GB/CY
Emptying the collection bag for
sandblasting material
Note: Do not reuse excess sandblasting material
from the collection bag
6
before it has been purified.
You can remove excess sandblasting material
which has collected in the collection bag
6
through the zip. Alternatively, you can loosen
the screw clamp
7
using a screwdriver and
remove the collection bag
6
from the product.
Troubleshooting
Error Possible cause Solution
No material flow The air is not dry enough. Install a water separator in
your compressed air system.
Air pressure is too low. Increase the pressure
of the compressor.
The attachment is not fitted
correctly. Ensure that the attachment fits tightly on the
product and that no air can leak from the
sides.
Blocked sandblasting material
lines. Check that there are no lumps of sandblast-
ing material blocking the lines. For best
results use a blow-out gun to clean blocked
lines (wear protective glasses!). Also check
the outlet of the tank.
The sandblasting
pattern is not as de-
sired. The air is not dry enough. Install a water separator in your
compressed air system.
The size of the sandblasting
material is not consistent. Replace the sandblasting material.
The sandblasting material is
contaminated. Purify/replace the sandblasting material.
The attachment is worn-out. Replace the attachment.
Other errors Contact a specialist or retailer.