in
Parking and access control equipment manufactured in the UK
Manual Sliding Gates
7
Manual Bullet Lock Guide
The gate is equipped with a bullet lock to keep the gate secure in
the closed
and open
position
's
. The picture left shows the main
components included.
You need to follow out the below procedure to fit this on site. This
cannot be fitted at the factory and needs fitting after the gate has
been fully installed.
If you have any questions please call our technical department.
The catch post has been fitted with a
housing that the above bullet lock fits into.
On first fitting when the gate is fully
open
and
closed you will need to drill a 12mm
hole in the lower gate main beam to
receive the end pin of the bullet lock
above. You will drill straight through dead
centre of this to ensure correct alignment.
When these steps are completed the
setup is complete.
Catch post side on
Welded Housing
for Bullet Lock
PLEASE REMEMBER TO ENSURE THAT THE LOCK IS REMOVED FOR ANY OPENING
AND CLOSING.
Picture Below shows gate with bracket
fitted.
