Parker Pro Display 10 Instruction Book
34/53
7.3. Ball / swivel mount
Swivel mounting for Pro Display is achieved by using the RAM
®
ball mount accessory –
see chapter 12 for ordering code of this option. The benefit of this installation method is
the possibility to adjust the display angle after assembly simply by loosening and again
tightening the wing nut in the swivel arm. This mounting method for Pro Display is
presented below.
To fasten the RAM 2,5" round plate, use 4 x M4 screws of class 8.8 or higher. It is
preferred to use Hex Socket Cap Screw ISO 4762 / DIN 912 or Pan Head Torx Machine
Screw ISO 14583 TX / DIN 7985 type.
Figure 20: Pro Display 10 swivel mount method using RAM ball. First RAM ball is installed
into rear side of the Pro Display and the second RAM ball into assembly surface of the
vehicle.
A. Attach the RAM ball into the rear side of the Pro Display and fasten it with 4 pcs
of M4 screws. Apply a torque of about
2,7
Nm.
B. Fix swivel arm loosely to RAM ball just attached into Pro display
C. Attach the RAM ball into vehicle’s assembly surface and fasten it with 4 pcs of
M4 screws, using tightening torque of about
2,7
Nm.
D. Take Pro Display and proceed with electrical connections of vehicle wire harness
plugs into Pro Display connector receptacles.
E. Take the swivel arm and loosen the wing nut in the middle so that you can attach
it first loosely into RAM ball in the back side of the Pro Display.
F. Place Pro Display near the RAM ball in the vehicle assembly surface and start to
adapt swivel arm open end into that. Loose the wing nut in the middle of the
swivel arm until the arm open end goes around the RAM ball in the vehicle side.
G. Start to tighten the wing nut at the same time you still hold the Pro Display with
your other hand.
H. Find most suitable angle for the Pro Display in the vehicle
I. Finish the wing nut tightening when Pro Display is mounted into suitable viewing
angle in the vehicle