Parker MDC 100 30 6.5, Руководство пользователя

Страница: 41 / 57

Parker Hannifin Manufacturing Srl user’s manual MDC
41
Bit Description M /O
0 Ready to switch on M
1 Switched on M
2 Operation enabled M
3 Fault M
4 Voltage enabled M
5 Quick stop M
6 Switch on disabled M
7 Warning O
8 Manufacturer specific O
9 Remote M
10 Target reached M
11 Internal limit active M
12 - 13 Operation mode specific O
14 - 15 Manufacturer specific
O
BITS 0 – 3, 5 AND 6:
The following bits indicate the status of the device:
Value (binary) State
xxxx xxxx x0xx 0000 Not ready to switch on
xxxx xxxx x1xx 0000 Switch on disabled
xxxx xxxx x01x 0001 Ready to switch on
xxxx xxxx x01x 0011 Switched on
xxxx xxxx x01x 0111 Operation enabled
xxxx xxxx x00x 0111 Quick stop active
xxxx xxxx x0xx 1111 Fault reaction active
xxxx xxxx x0xx 1000 Fault
Table 7: Device state bits (x ... irrelevant for this state)
BIT 4: VOLTAGE ENABLED
High voltage is applied to the drive when this bit is set to 1.
BIT 5: QUICK STOP
When reset, this bit indicates that the drive is reacting on a quick stop request. Bits 0, 1 and 2
of the
statusword must be set to 1 to indicate that the drive is capable to regenerate. The
setting of the other bits indicates the status of the drive (e.g. the drive is performing a quick
stop as result of a reaction to a non-fatal fault. The fault bit is set as well as bits 0, 1 and 2).
BIT 7: WARNING
A drive warning is present if bit 7 is set. The cause means no error but a state that has to be
mentioned, e.g. temperature limit, job refused. The status of the drive does not change. The
cause of this warning may be found by reading the fault code parameter. The bit is set and
reset by the device.