40
Parker Hannifin Corporation
Hydraulic Pump/Motor Division
Greeneville, Tennessee USA
HY13-1524-002-M1/US
Disassembly & Inspection
Service Manual
HTG Series Integrated Hydrostatic Transmission
HY13-1528-001-M1/US—HTG Series Service Manual
Disassembly and Inspection
Step
Instruction
Illustration
Remove section seal from both
sides of the manifold.
It may be necessary to use a flat head
screwdriver to lift out the two section seals.
Be careful not to scratch or damage the
motor parts.
Remove the thrust washer.
Remove the thrust washer from the top of
drive link.
Add alignment marks on drive
link and rotor.
3. Mark the same location on the rotor for
alignment on re-assembly.
1. Make sure the surface is clean and free
of debris so marks will adhere.
2. Mark tip of drive link.
