Parker 716 Series, Руководство по обслуживанию

Страница: 23 / 28

Parker Hannifin Corp.
Hydraulic Pump/Motor Div.
Greeneville, TN 37745 USA
19
14. Place the cover (2) so the port markings ( IN ) ( IN ) are lined
up with the corresponding ports. Also check the square ring
seal (3) to verify that it hasn’t dropped out. SEE FIGURE A11.
15. Install lubricated bolts (1) and torque diagonally to 15 ft lbs.
A. Increase torque diagonally 5 foot lbs on each bolt.
B. Rotate the shaft by hand through several rotations.
C. Repeat steps A & B until torque is 30 foot lbs.
SEE FIGURE A12
16. Turn motor right side up in the vice and install the square cut
seal (3) in the center block seal gland. SEE FIGURE A13.
17. Place the commutator plate on the center block with the
square ring groove facing up. Align the 8 bolt holes with the 8
tapped holes in the center block. SEE FIGURE A14
Figure A11
Figure A12
➞
➞
Motor Assembly
Figure A13
Figure A14