Parker 716 Series, Руководство по обслуживанию

Страница: 14 / 28

Parker Hannifin Corp.
Hydraulic Pump/Motor Div.
Greeneville, TN 37745 USA 10
!
!
!
Disassembly and Inspection
(Preparation Before Disassembly)
• Before you disassemble the motor unit or any of its components read this entire
manual. It provides important information on parts and procedures you will need
to know to service the motor.
• Refer to page four for tools and other items required to service the motor and
have them available.
• Thoroughly clean off all outside dirt, especially from around fittings and hose
connections, before disconnecting and removing the motor. Remove rust or
corrosion from coupling shaft.
• Remove coupling shaft connections and hose fittings and immediately plug port
holes and fluid lines.
• Remove the motor from system, drain it of fluid and take it to a clean work
surface.
• Clean and dry the motor before you start to disassemble the unit.
• As you disassemble the motor clean all parts, except seals, in clean petroleum
based solvent, and blow them dry.
WARNING: SINCE THEY ARE FLAMMABLE, BE EXTREMELY
CAREFUL WHEN USING AND SOLVENT. EVEN A
SMALL EXPLOSION OR FIRE COULD CAUSE INJURY
OR DEATH.
WARNING: WEAR EYE PROTECTION AND BE SURE TO COMPLY
WITH OSHA OR OTHER MAXIMUM AIR PRESSURE
REQUIREMENTS.
CAUTION: Never steam or high pressure wash hydraulic
components. Do not force or abuse closely fitted parts.
• Keep parts separate to avoid nicks and burrs.
• Discard all seals and seal rings, as they are removed from the motor. Replace all
seals, seal rings and any damaged or worn parts with genuine Ross or OEM
approved service parts.