ASSEMBLY
The
Waterbox
1
Attach Wheel Assembly
K
to Base
J
. Align holes to the
Base, and insert 2 Small Bolts through the holes
Hardware Used: 2x Small Bolts
2
Attach the Post Supports
I
to the Base
J
. Align the holes
in the bottom of each Post Support with the hole on the
Base. Insert 1 Small Bolt through the hole in the support
and into the Base and hand tighten. Repeat with the other 2
Post Supports and then tighten all bolts with the Wrench .
Hardware Used: 3x Small Bolts
Waterbox Cap
Base
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents
list and hardware contents as listed on page of this manual. If any part is missing or damaged, do not attempt to
assemble this product. Contact customer service for replacement parts.
ESTIMATED ASSEMBLY TIME: 60 minutes
Tools Required for Assembly (NOT included):
Note: This heater has an Electronic Ignition and will require installation of 1 – AAA battery. The battery should be installed
by unscrewing the RED IGNITER BUTTON – battery not included.
Contact us for assistance: [email protected] | (800) 561-5550
