MUM2-A2-GZ40-00
September 2004
3
Product Documentation Online
Complete documentation for Paradyne products is available at
www.paradyne.com
. Select
Support
→
Technical Manuals
.
To order a paper copy of a Paradyne document, or to speak with a sales
representative, please call 1-727-530-2000.
Release Notes
Release notes for this product are available in the subscriber firmware area of
www.paradyne.com
. Select
Support
→
Subscriber Firmware
.
Always review the relevant release notes before installing a new card.
MUM2000-2 Overview
The MUM2000-2 Multiplexer Uplink Module provides gigabit Ethernet uplink
support capability and enhanced management functionality for the 4000, 4000E,
12000 and 12000E Ethernet-based Broadband Access Concentrators (BACs).
The MUM2000-2 has two modular Uplink Interface Module (UIM) slots, allowing
combinations of T1, E1, DS3, E3, 10/100BaseT, and gigabit Ethernet (1000BaseT
or fiber) uplinks.
The MUM2000-2 includes IP Multicast support that allows the BAC to deliver
broadcast television over high speed access lines (typically 10+ Mbps ADSL). This
IP Multicast support (including IGMP snooping) ensures that video traffic is
intelligently forwarded only to those modules and ports that are requesting the
particular video stream and protects other modules and ports from receiving
unwanted traffic.
The MUM2000-2 supports up to 384 DSL ports.
Unpacking the MUM2000-2
HANDLING PRECAUTIONS FOR
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
Unpack and Inspect the Multiplexer Uplink Module (MUM). If there is visible
damage, do not attempt to install the MUM2000-2; notify your sales or service
representative.
!
