Paradyne Hotwire 8620, Руководство по установке, Страница: 33 / 58

2. Installation
8620-A2-GN20-50 June 2004
2-15
Procedure
To install a circuit card in the 8620 BAC:
1. Remove the filler plate from the slot by unscrewing the mounting screws at
each end.
2. Hold the card horizontally with the components on top, and insert it into the left
and right card guides of the slot of the base chassis.
3. Carefully slide the card into the slot until the card meets the connectors on the
backplane. Then press in on the insertion/ejection levers until the card is fully
seated.
4. For desktop installations, press on the card’s front panel with one hand and on
the back of the 8620 chassis with the other until the card’s connector seats in
its mating connector.
5. Make sure the SYSTEM OK indicator (on line cards) or SYSTEM ACTIVE
indicator (on the SCP card) is cycling off and on. If not, refer to
Troubleshooting Table in Chapter 4, Troubleshooting .
6. Secure the card by fastening the screws on each end of the faceplate. This is
required to maintain proper gasket pressure on the faceplate as well as proper
air flow.
NOTE:
For detailed information about the configuration and operation of the circuit
card, see the appropriate card User’s Guide.
04-17430-01
ESD
SIM
A
1
2
3
AC INPUT
DC FUSES
A B
-48V RTN
A B A B
A B
DC
POWER
F
A
N
M
A
J
O
R
M
I
N
O
R
ALARMS ALARM CLOCK
A B
SERIAL
SCM MCP
LAN
SCM MCP
SIM
SYSTEM
Activ
e
Standb
y
Alar
m
TX RX
ETHERNET
Test
UPLINK
LK1 LK2 LK3 LK4
LK5 LK6 LK7 LK8
SCP-IMA
8417
G.DMT G.Lite
8965
SYSTEM
OK Alrm Test TX RX LOC 1/13 2/14 3/15 4/16
ATM
BU
S
DSL POR
T
5/17 6/18 7/19 8/20
POR
T
9/21 10/22 11/23 12/24
POR
T
AL
T BANK
13-24 1-12
G.DMT G.Lite
8965
SYSTEM
OK Alrm Test TX RX LOC 1/13 2/14 3/15 4/16
ATM
BU
S
DSL POR
T
5/17 6/18 7/19 8/20
POR
T
9/21 10/22 11
/23
12/24
POR
T
AL
T BANK
13-24 1-12
G.DMT G.Lite
8965
SYSTEM
OK Alrm Test TX RX LOC 1/13 2/14 3/15 4/16
ATM
BU
S
DSL POR
T
5/17 6/18 7/19 8/20
POR
T
9/21 10/22 11/23 12/24
POR
T
AL
T BANK
13-24 1-12