Paradyne Hotwire 8620, Руководство по установке, Страница: 23 / 58

2. Installation
8620-A2-GN20-50 June 2004
2-5
8620 BAC Installation
The 8620 BAC is designed to be placed on a desktop or table, or mounted in a
19-or 23-inch rack (front or center mount). Installable feet are provided for desktop
or table installations. Mounting brackets are provided for mounting in 19- or
23-inch racks.
NOTE:
Do not attach the rubber feet to the chassis if you plan to install it in a rack.
The rubber feet will cause the chassis to exceed 3U in height, limiting the
maximum number of chassis that can be installed in a rack.
You will need a large flat-blade screwdriver and a Phillips screwdriver to install the
8620 chassis.
Placing the 8620 Chassis on a Desktop or Table
Procedure
To install the 8620 chassis on a desktop or table:
1. Make sure that the bottom of the chassis is clean so that rubber feet will stick
to its surface.
2. Invert the chassis on a protected surface (to avoid scratching the paint).
3. Remove the protective backing from one of the rubber feet and place it in a
corner about 1/2 inch (1.27 cm) from each of the edges of the chassis,
pressing down firmly to ensure proper bonding.
4. Repeat Step 3 for each of the remaining three feet.
5. Turn the chassis right side up and place on a flat surface where desired.