Paradyne GranDSLAM 4200, Руководство по установке

Страница: 34 / 68

2. Cabling
2-10
October 2002 4200-A2-GN20-10
Console Port
The CONSOLE port normally serves as the primary user interface with the
GranDSLAM 4200 during installation. You can connect a terminal or PC directly to
the CONSOLE port using a DTE cable (see procedure below). You can also use
the CONSOLE port to attach a modem to the GranDSLAM 4200 for remote dial-in
management of the unit using a DCE cable (see procedure on next page).
Procedure
To connect a terminal or PC to the CONSOLE port:
1. Configure the terminal or terminal emulation program to use the following
parameters:
— Maximum speed: 9600 bps
— Data bits: 8
— Parity: None
— Flow Control: None
— Stop bits: 1
2. Determine and procure the proper Data Terminal Equipment (DTE) cable type.
The CONSOLE port requires a DB9 plug connector. The other connector
depends on the serial port on your terminal or PC.
3. Connect the DB9 plug connector to the CONSOLE port socket. The
CONSOLE port is ordinarily used only during installation, so do not fasten the
connector.
4. Connect the other end of the cable to the serial port of your terminal or PC.
02-17271
1
12
13
24
DSL PORTS 1-2
4
4
8
16
20
POWER
A
ALARM
RTN -48VDC
BITS
MGMT
CONSOLE
ST
AT
US
UP
LI
NK
AL
RM
TE
ST
B
A
3.5 A 60
B
E1 MODULE
4202
TX
RX
100/120
W
75
W
Serial
Port
CONSOLE
Port