Paradyne FrameServer SLV 9520-ILM, Руководство по установке

Страница: 19 / 28

19
Configuring SNMP Trap Managers and Traps
Once the FrameSaver unit is connected to the network, SNMP trap managers and
SNMP traps can be configured.
Procedure
To enter SNMP managers and configure traps:
1. Select SNMP Traps.
Main Menu
→
Configuration
→
Management and Communication
→
SNMP Traps
2. Configure the following:
— Enable SNMP Traps.
— Identify the total Number of Trap Managers.
— Specify the IP address of the NMS(s) to which traps will be sent.
— Specify the Initial Route Destination for the Trap Manager(s).
— Select desired trap categories.
3. Save the configuration.
4. Return to the Main Menu.
Verifying the End-to-End Path
After installation, run an IP Ping test to ping the NMS at the NOC and verify that the
entire path from the unit to the NMS is functioning. To run the IP Ping test, SNMP trap
managers must have been configured for the FrameSaver unit. One of those trap
managers must be the NOC NMS.
Procedure
1. Select the IP Ping test.
Main Menu
→
Test
→
IP Ping
2. Enter the IP Address of the device being pinged, then select Start.
NOTE:
When running tests, the cursor is positioned over the Start command. Press
Enter to start the test. Stop is displayed while the test is running. Press Enter
again to issue the Stop command.
— While the test is running,
In Progress...
appears in the Status field.
— When the test is finished,
Alive. Latency =
nn ms
should appear as the
Status ( nn being the amount of time the test took in milliseconds).
If any other message is displayed, additional testing will be required.
See the
FrameSaver SLV Operations Guide (9000-A2-GB33)
for information about IP
Ping-related messages.