Paradyne COMSPHERE 3610, Руководство оператора

Страница: 6 / 310

COMSPHERE 3600 Series Data Service Units
E July 1999 3610-A2-GB91-90
The DDS Service Order Number is 6.0Y. The jack configurations required are RJ48S for the
Model 3610 DSU and RJ48T for the Model 3611. With an RJ48T configuration, you must specify
the number of data lines you require. Refer to the Technical Specifications section of Chapter 1 for
V.32 DBM jack information.
After the telephone company has installed the requested jack, you can connect the DSU with the
appropriate cable (provided). An FCC-compliant telephone cord and modular plug is provided
with this equipment. This equipment is designed to be connected to the telephone network or
premises wiring using a compatible modular jack that is Part 68 compliant.
Canada
Notice to Users of the Canadian Telephone Network
The Canadian Department of Communications has certified that this equipment meets certain
telecommunications network protective, operational, and safety requirements. The Department
does not guarantee that the equipment will operate to the user’s satisfaction.
Before installation, you should make sure that it is permissible to connect this equipment to the
local telecommunications company’s facilities. The equipment must be connected by an acceptable
method. In some cases the telecommunications company’s inside wiring associated with single-line
individual service may be extended with a certified connector assembly (telephone connection
cord). The customer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
If you experience difficulty with this equipment and require service, refer to the Equipment
Warranty and Support section of Chapter 1 in the COMSPHERE 3600 Series Data Service Units,
Models 3610 and 3611, Dial Backup Module and SNA Diagnostic Interface Options, User’s Guide,
which is shipped with the DSU.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility.
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may
cause the telecommunications company to ask you to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
CAUTION
Users should not attempt to make such connections themselves,
but should contact the appropriate electric inspection authority,
or an electrician, as appropriate.
The load number (LN) is labeled on the equipment. The LN denotes the percentage of the total
load to be connected to a telephone loop used by this equipment. To prevent an overload, the total
of the LNs of all devices attached to the loop may not exceed 100. The LN also specifies the
appropriate ringing type (A or B), if applicable. For example, LN = 20A designates a load number
of 20 and an “A” type ringer.