Paradyne COMSPHERE 3610, Руководство оператора

Страница: 214 / 310

COMSPHERE 3600 Series Data Service Units
C-12 July 1999 3610-A2-GB91-90
Table C-9
(1 of 2)
Point-to-Point Dial Backup Error Messages
Message Notify NMS
1
Condition Action
DBM: Busy Yes Telephone line associated
with remote DBM is busy. Try again. Try another number if
possible, or investigate why the line is
busy.
DBM: Call
Aborted No Call was aborted from the
DCP. None.
DBM:Callbck Fail No There was a failure to
connect on a callback
attempt. Make sure you have the correct call
setup pointer and that remote DBM has
the proper telephone number in that
directory. If both are correct, attempt to
place a manual call from the remote
DBM.
DBM:
Conflict w/Envir Yes DBM is not able to dial out
(e.g., test is being run); there
is no DBM at the far end. Wait until the test is completed, or abort
the test.
DBM:Dir Empty Yes An attempt was made to
place a call from an empty
directory. Check Backup Directory entries and
numbers.
DBM:DTR Discon Yes DTR has gone low, or the
call did not connect. Raise DTR at the DTE, or disable the
DTRCallCon configuration option.
DBM:Illegal Char Yes Illegal character in the
directory specified. Check directory entry.
DBM:NetwkAbort No Call was aborted by the
network. Try again.
DBM:NetwkBusy Yes Call was unable to place call
at the time. Try again.
DBM:NetwkUnavl Yes Network is incapable of
passing data. Look for line problems. If conditions are
good and no problem is found, call
telephone company and report the
problem.
DBM:No Answer Yes There was no answer from
the remote DBM or modem. 1. Check that remote DBM is configured
for many calls.
2. Make sure remote DBM is properly
connected to the PSTN.
3. Check operational status of remote
DSU using a Device Test.
4. Attempt to place a call from remote
DBM. If it cannot be placed, replace
the DBM.
1
If Yes, an error message is reported to the NMS if the NMS initiated the Dial command.