Paradyne COMSPHERE 3610, Руководство оператора

Страница: 281 / 310

K-1 3610-A2-GB91-90 July 1999
DMC Commands
Overview K-1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Overview
Table K-1 lists the DMC tests and commands
supported by the 3600 Series DSUs in conjunction with an
ANALYSIS
t
6510 system console.
NOTE
A DBM in Slot 16 cannot be
addressed from the
ANALYSIS 6510 system console.
In a 3600 Series DSU, commands can be addressed to
both controls and tributaries if the control DSU is
equipped with version 2.4 or greater firmware.
Table K-1
(1 of 2)
ANALYSIS 6510 NMS DMC Commands
NMS Command Description
Autoscan Retrieves the health and status of a DSU or DBM.
Device NOOP Checks to see if DSU responds to a valid command.
Returns either an A (ACK) or N (NACK).
Device Self Test Initiates the Device Test on a DSU or DBM. Returns a Pass or Fail to NMS.
Diagnostic Self Test Retrieves diagnostic information from a DSU or DBM.
DSU Disable Disables a control DSU or DBM.
The DSU or DBM will still respond to test and loopback commands. If a test is
in progress, the device responds with a NACK. After the test has been
terminated, the operator must enter the command again.
DSU Enable Enables a control DSU or DBM for normal operation.
Test conditions are not affected by this command. If a test is in progress, the
device responds with a NACK. After the test has been terminated, the
operator must enter the command again.
1
These selections are described in more detail in Appendix J .
2
A DBM speed of 12 kbps is reported as 64 kbps.
K