16
May
2005
AIM2-A2-GZ40-20
Fixed – An AIM24000 port set to port mode fixed will maintain consistant
upstream and downstream bandwidths as specified by the user. The link is
lost if the speed cannot be maintained.
Fixed Adaptive – An AIM24000 port set to port mode fixed adaptive will
automatically train up to the best possible speed supported by the AIM24000,
the ADSL modem at the remote end, and the copper cable pair connecting the
two, within the confines of user-specified maximum upstream and downstream
bandwidths. The modems will train at a lower speed if line conditions
deteriorate.
Off – An AIM24000 port set to port mode off has been administratively turned
off.
Filter IP Address Settings
IP Range 1 Default: 0.0.0.0 – 225.255.255.255
IP Range 2–4 Default: 0.0.0.0 – 0.0.0.0
IP Range filtering is user-defined via configurable starting and ending IP
addresses that specify an acceptable range of source IP addresses for incoming
packets. Up to four IP ranges may be configured per port in the NMS, and up to
two IP ranges may be configured per port via the CLI or SNMP.
Single IP Address
Starting IP Address = Ending IP Address
An AIM24000 port configured with a single source IP address will only allow
packets with that specific IP address to traverse the port.
IP Address Range
Starting IP Address < Ending IP Address
An AIM24000 port configured with a source IP address range will allow packets
having an IP address within the specified range to traverse the port.
Full IP Address Range
Starting IP Address = 0.0.0.0
Ending IP Address = 255.255.255.255
An AIM24000 port configured with the full range of source IP addresses will allow
packets with any source IP address to traverse the port.
Rate Limit
Default Ingress Limit: 0
Default Egress Limit: 0
Rate limiting restricts the bandwidth of incoming or outgoing unknown unicast,
unknown multicast, and broadcast traffic. Specify a rate in kbps for ingress and
egress packets.
