Paradyne 12000, Руководство по интерфейсу командной строки

Страница: 13 / 42

1. CLI Overview
CLI-A2-GB20-00 October 2004
1-5
System Reset/Reboot
A system reset clears Micro DSLAM or IP DSLAM interface module RAM. It does
not clear NVRAM; system and port settings remain as configured. A system reset
takes approximately one minute to complete, after which you will be required to log
back in.
Manual Reset
„
Micro DSLAM
Using a paperclip, mechanical pencil or similar tool, press the Reset Button on
the chassis faceplate once.
„
IP DSLAM
— Single Card: Slide the card you want to reset out of the DSLAM chassis far
enough to disengage the module connector at the back of the chassis.
Ensure the power LED on the card’s faceplate is no longer illuminated and
wait 10 seconds before sliding the card back into the chassis.
— All cards in DSLAM: Power down the DSLAM chassis and wait 10
seconds before restoring power. This resets all chassis interface modules
in addition to the MUM2000-2 or BSX8000-5.
Reset Via CLI
To reset a device with the CLI, use the Reset command. See Reset in Chapter 3,
CLI Commands .
Clearing NVRAM
Clearing NVRAM on the IP DSLAM or Micro DSLAM restores all system and port
configurations to original default settings.
Manual Clear
„
Micro DSLAM
Using a paperclip, mechanical pencil or similar tool, press the Reset Button on
the chassis faceplate once. After approximately 2 seconds, the green Link
LEDs will flash from port 1 to port 5. Immediately hit the reset button again.
After the Micro DSLAM reboots, NVRAM will be cleared.
„
IP DSLAM
Remove all cards from the DSLAM chassis. Reinstall the management card
(MUM2000-2 or BSX8000-5) alone. Wait at least one minute, then install the
other cards.
Clear NVRAM Via CLI
To clear NVRAM with the CLI, use the Clear command. See Clear NVRAM in
Chapter 3, CLI Commands .