Magellan / Spectra SP
15
Part 3: Programming Methods
3.1
WinLoad Software for Windows
Program the control panels remotely or on-site using the WinLoad Software (V2.80 or higher) for Windows®. For more
information, contact your local Paradox Distributor or visit our web site at paradox.com. If you are using the WinLoad software,
you must program the features (see
Settings for WinLoad Software
on page 58). Update the panel’s firmware by connecting it to
a PC via a 307 Direct Connect Interface and then using the Winload software. (Not investigated by UL).
3.2
Programming Using a Keypad
Use the supplied
programming guide to keep track of which sections were programmed and how. We recommend you read the
entire manual before you begin programming.
3.2.1
Single Digit Data Entry Method (Decimal and Hexadecimal)
Single Digit Data Entry is used in all sections except those specified in the Feature Select Programming Method
(below). After entering Programming Mode as described in the shaded box above, some sections will require that you
enter
Decimal
values from
000 to 255
. Other sections will require that you enter
Hexadecimal
values from
0 to F
. The
required data will be clearly indicated in this manual as well as in the programming guide. When entering the final digit
in a section, the control panel will automatically save and advance to the next section. Except sections 001 to 032,
after entering the first three digits the control panel will switch to Feature Select Programming. For phone number
programming, press
[
ENTER
] to save the data.
3.2.2
Feature Select Programming Method
After entering certain sections, eight options will be displayed where each option from
[1]
to
[8]
represents a specific
feature. Press the key corresponding to the desired option. This means the option is ON. Press the key again to
remove the digit, thereby, turning OFF the option. When the options are set, press the
[
ENTER
]
key to save and
advance to the next section.
How Do I Enter Programming Mode?
1) Press
[
ENTER
]
2) Enter your
[
INSTALLER
CODE
]
(default: 0000 / 000000) or
[
MAINTENANCE
CODE
]
(empty by default)
3) Enter 3-digit
[
SECTION
]
you wish to program
4) Enter required
[
DATA
]
Table 2: Decimal and Hexadecimal Programming Table
Value or Action
What Do I
Press?
What Do I See?
32-zone LED
10-zone LED
Value 0 / Replace Current Digit
with 0
[
SLEEP
]
Erase digit and remain in section Erase digit and remain in
section
Values 1 to 9
[1] to [9]
Zone 1 to 9
[1]
to
[9]
A (hex only)
[0]
Zone 10
[0]
B (hex only)
[
OFF
]
Zone 11
[
OFF
]
C (hex only)
[
BYP
]
Zone 12
[
BYP
]
D (hex only)
[
MEM
]
Zone 13
[
MEM
]
E (hex only)
[
TBL
]
Zone 14
[
TBL
]
F (hex only)
[ ]
Zone 15
[ ]
Exit Without Saving
[
CLEAR
]
A
RM
& S
TAY
LED flash
A
RM
& S
TAY
LED flash
Save Data (hex only)
[
ENTER
]
Advances to the next section
Advances to the next section
