Paradox K07C, Справочное и монтажное руководство, Страница: 13 / 28

EVO/DGP System Programming PAGE 13
Entering Module Programming Mode
Like all other keypads in the system, Grafica is programmed through the
control panel. To do so, you must enter the panel’s Module Programming
Mode:
1. From Normal Mode press and hold the [0] key.
2. Enter the [
INSTALLER CODE
] (by default 000000).
3. Enter section [4003] .
4. Enter Grafica’s 8-digit [
SERIAL NUMBER
] .
5. Enter the 3-digit [
SECTION
] you want to program.
6. Enter the required [
DATA
] .
The control panel will then redirect all programming to the selected
Grafica keypad. Use the scroll and action keys (see Figure 1 on page 6)
to navigate through desired sections.
NOTE: The keypad’s serial number is located on the PCB, or enter
section [0000] in step 3 to view Grafica’s version and serial number.
Programming Methods
The following methods can be used when programming the Grafica
keypad:
Feature Select Programming
You can program sections by enabling or disabling options. Within
these sections, keys
[1] to [8] or scroll keys represent a specific
Grafica option. Use the scroll keys to highlight the desired option and
press the corresponding action key to enable or disable the option.
An “
X ” will appear to indicate that the option is enabled. Press the
appropriate action key to save the status of the selected options.
Decimal Programming
Some sections require the entry of a decimal value. For this method,
any value from 000 to 255 can be entered.
Hexadecimal Programming
Some sections require the entry of hexadecimal values A to F . Press
the [#] key to scroll through these values. If the value is left
unchanged for two seconds, Grafica will automatically select it and
move forward to the next digit.