3
Others
Press [ENTER] [2828] or [282828], you are in the programming mode, ENTER key is flashing
1. Keypad setting
[key in 090][ON key 11][ENTER][CLEAR], for keypad zone 1
[key in 090][ON key 12][ENTER][CLEAR], for keypad zone 2
Select the jumper at the keypad, J1 OFF is keypad 1 and J1 ON is keypad 2.
Power down and on again after changing the jumper setting.
2. Keyswitch
[key in 086][ON key 3][ENTER][CLEAR], to enable keyswitch
Connect a 500 ohm resistor in series with AUX of keypad black wire & another wire connect to GRN of
keypad green wire.
500 ohm
resistor
3. Partitioning
[key in 086][ON key 8][ENTER][CLEAR], to enable partitioning
ON relevant key [1 to 10] for ZONE to be at partition A or B
[key in 116], for zone Partition A
[key in 120], for zone Partition B
ON relevant key [1 to 10] for USER to use in Partition A or B
[key in 062], to allows user 1 to 10 in Partition A
[key in 068], to allows user 1 to 10 in Partition B
Note: Once the system in Partition, Stay and Away/Force features are not available.
AUX
AUX
+
-
GRN
YEL
COM
NO
keyswitch
