3
Programming Sections
The following describes the programming sections which must be set in order for the Printer Module to act as an interface between a
Digiplex control panel and a C-Bus PC interface.
To access the Printer Module’s programming mode:
1.
Press and hold the
[0]
key.
2.
Enter the
[
INSTALLER
CODE
]
.
3.
Enter section
[953]
(DGP-848) /
[4003]
(EVO).
4.
Enter the Printer Module’s 8-digit
[
SERIAL
NUMBER
]
.
5.
Enter the 3-digit
[
SECTION
]
you want to program.
6.
Enter the required data.
The Printer Module can also be programmed using the WinLoad Security Software (V2.62 or higher) or using the control panel’s
Module
Broadcast
feature. Refer to the
EVO or DGP-848
Reference & Installation Manual
for more details. Please note that the serial number can
be located on the Printer Module’s PC board.
Serial Port Setup
The following lists the serial port programming options which must be set in order for the Printer Module to communicate with C-Bus.
When this option is ON (enabled), you can connect the C-Bus PC interface directly to the Printer Module’s serial port (9 pins) through the
use of a null modem cable. Set option
[4]
to ON when using the Printer Module as an interface between a C-Bus PC interface and the
Digiplex system.
When a C-Bus PC interface is connected to the Printer Module, the serial port baud rate is automatically set to 9600 baud. Any other baud
rate will be overridden.
This option allows you to set the Printer Module’s serial port usage to either Event Reporting or Home Automation. Set option
[4]
to ON to
set the Printer Module to Home Automation.
This option allows you to select the home automation protocol for the Printer Module. Set option
[5]
to
ON and option
[6]
to OFF to select the Clipsal C-Bus Protocol.
For more information on the ASCII Protocol, see the ASCII Protocol Programming Instructions
on our website at paradox.com.
Section [016] - Option [1]
Enable Serial Port
Section [016] - Options [2] & [3]
Baud Settings
Section [016] - Option [4]
Serial Port Usage
Section [016] - Options [5] & [6]
Home Automation Options
