SNMP-NET
15
SNMP Access Control Setting
SNMP-NET supports SNMP protocol. You can use an NMS to manage the UPS through the
network. The IP address of the workstation must be entered in the SNMP-NET write access
table to prevent unauthorized users from configuring SNMP-NET via SNMP protocols.
Power Fail/Restore Simulation
To make sure the network configuration is correct, SNMP-NET provides two test buttons to
simulate power fail and power restore events. After pressing the test buttons, SNMP-NET will
send the related SNMP trap to the assigned target hosts and simulate the power event values to
SNMP response data. The power fail simulate will be terminated automatically in 30 minutes.
Updating SNMP-NET Firmware from Windows
To perform firmware upgrade, use the
EzSetting.exe
program on the CD-ROM.
1.
Device List:
Displays the addresses of the SNMP-NET devices present in the local
network.
2.
Discover:
Search for the SNMP-NET devices in the local network.
3.
Add:
Allows you to add the IP address of the SNMP-NET device manually.
4.
Modify:
Allows you to modify the parameters of the selected SNMP-NET device.
5.
Remove:
Removes the selected SNMP-NET device from the Device List.
6.
Configuration:
Provides an easy way to do the initial configuration through networking
UDP port 3456. If you cannot get the device information please check and open the UDP
port from your OS.
7.
Upgrade:
Allows you to upgrade the firmware for the SNMP-NET device.
