ENGLISH
OPERATING AND MAINTENANCE MANUAL
5
L
Do not use the wheel gun with the screws
of the clutch cover
(view figure Fig.1-E
)
or the motor cover (
view figure Fig.1-P
)
loose or not tight enough (
see table Tab.
A “Tightening Torques”
). If not tighten
them with a torque wrench following the
tightening sequence shown (
view figures
Fig.2-F and Fig.2-G
).
L
Pay attention to the exhaust coming out
by the wheel gun during operation (
view
figure Fig.2-B
). To avoid compromise the
performance of the wheel gun, not obstructed
in any case these holes of exhaust.
L
Wheel gun intended to be used for
professional use by trained personnel and
equipped with appropriate technical skills.
L
Do not operate the wheel gun without the
prescribed safety devices.
L
The drive shaft of the wheel gun and the
socket fixed to it may continue to rotate for
a short time after the release of the trigger.
L
Verify that the WARNING label (
view figure
Fig.1-W
) is present and legible, otherwise
replace it by applying new one in the original
position.
GENERAL INSTRUCTIONS
Original operating instructions
-
The original language of these instructions is English.
L
Always use a wheel gun with the tightening
torque corresponding to the one required
by the application.
L
Please pay attention to the position of the
lever for change of directionality (
view figures
Fig.1-L and Fig.2-H
) of your wheel gun:
⚪
in LH position (Fast Left Hand) it loosens
nuts tightened clockwise faster;
⚪
in RH position (Fast Right Hand) it loosens
nuts tightened anticlockwise faster.
L
In order not to compromise the functionality
of the rotation reverse shaft, do not unscrew
or loosen never the grub screw of the motor
cover (
view figure Fig.2-D
).
L
The modes for the correct grip intended
for use of the wheel gun is as follows
(view
figure Fig.2-E
):
⚪
right hand grip on the gun body;
⚪
left hand grip on the surface of the hammer
case.
L
The standard adjustment of the force
necessary for the translation of the rotation
reverse shaft, and thus the reverse is
already performed by Dino Paoli s.r.l.. A
personalized set of this force is possible,
however, for specific needs of the operator,
acting uniformly on the nr.2 (two) rotation
reverser grub screws (
view figure Fig.2-C
).
Tightening the grub screws you will have
an increase in the force required, loosening
them you will have its decrease. Ensure
that the individual regulation does not
create problems of accidental reversal
of the direction of rotation. Perform this
adjustment always disconnected the wheel
gun from the air supply.
OPERATING INSTRUCTIONS
TAB. A
TIGHTENING TORQUES
Clutch Cover
M6 Screw
18 Nm
Motor Cover
M5 Screw
10 Nm
Содержание DP 6000 BIAS
Страница 55: ...ATTACHMENTS TECHNICAL CHARTS 55...
Страница 56: ...ATTACHMENTS TECHNICAL CHARTS 56...
Страница 58: ...ATTACHMENTS TECHNICAL CHARTS 58 Fig 4 3 PORT GUN SELECTOR PLATE STANDARD CLOCKWISE ANTICLOCKWISE...
Страница 59: ...ATTACHMENTS TECHNICAL CHARTS 59 Fig 6...