6–2
6.1
Pre-maintenance Check
一、Environment
1.
The power voltage must be in the range of 220~240 VAC, depending on the
model.
2.
Place the equipment on a flat, stable surface.
3.
Room temperature is maintained between 10°C and 32.5°C. Relative humidity
should be between 20% and 80%.
4.
Do not expose the equipment to dust.
5.
Do not expose the equipment to ammonia or other noxious gases.
6.
Avoid exposing the equipment to heat or moisture (e.g. near water or a
humidifier).
7.
Avoid exposing the equipment to direct sunlight.
8.
Use the printer in a well-ventilated room.
9.
Make sure the printer's air vent is not blocked.
二、About paper
1.
Check whether the paper used is within the specified range. [Printing with
paper that is too thick, too thin, or curled may result in paper jams, feed
problems or poor print quality]
2.
Do not use damp or wet paper. [If paper is damp or wet, please replace with dry
paper and check to see if the quality improves]
3.
Do not use short-grained paper or acid paper. [If you use short-grained paper
or acid paper, it can cause print quality problems]
三、Consumables
1.
Replace the cartridge when the indicator on the printer control panel flashes
yellow.
2.
Check that the specified Pantum cartridge is being used. For more information,
please see
5.2"Consumables"
.
Содержание P2200 Series
Страница 1: ...Maintenance Monochrome Laser Printer P2200 P2500 Series Manual...
Страница 12: ...1 3 1 1 2 Rear View 1 Network Interface 2 USB Interface 3 Power Switch 4 Power Interface...
Страница 42: ...2 21 Demo Page...
Страница 90: ...6 6 6 4 2 Inside Jam 1 Open the upper cover 2 Remove the cartridge along the guides...
