Option A
(Recommended)
2
. Insert the two roll holders into the roll media support set then place the
roll media directly between the two roll holders (Figure 4-22).
Option B
(Use the media fl anges)
Insert a roll media fl ange at the end of each roll media and tighten the
thumbscrew until the roll media is fi rmly gripped (see Figure 4-23).
Then put the roll media on the roll holders. Adjust the position of the roll
media ensure that media fl anges are able to run in the grooves of media
guide bushes. (Figure 4-24)
3
. Load the media on the platen. Please refer to “4.4.1. Loading the sheet
media.” After loading the roll media, fl atten the media on the platen and
hold the front edge of the roll media fi rmly (Figure 4-25).
Figure 4-22
Figure 4-23
Figure 4-24
Figure 4-25
4. Operation Procedure 4-9
