Panta Rhei Hydro Wizard ECM 63, Руководство пользователя, Страница: 19 / 36

19
Operation
Initial start up
After the hydro wizard is plugged in for the first time you must set the
language, time and date.
These settings can be changed later in the info menu
Selecting the mode
Select the desired mode in the main menu, in the change mode
screen.
Changing the mode on the screen will change it without
confirmation. The mode will operate with the currently active
settings
In case of a power failure the pump will not restart on its own. The
settings are saved and will be available after a power failure.
When power is re-established the hydro wizard will be stopped.
Flow mode
The flow mode is used to make a steady flow in the tank. After
selecting the flow mode select the strength of the flow (in %) in
the settings menu, or the quick change field in the info menu. If the
pump is stopped (blinking “STOP” field in the info menu) the
settings will take effect after the Stop button is pressed again. If not
they will take effect RIGHT AWAY. It is best to change the flow while
the pump is running, and it is easier to observe the changes in the
aquarium. You can stop the pump by selecting a flow of 0% or
pushing the STOP field in the menu or info screen.
Always increase the flow slowly and carefully observe the changes
for some time
The flow mode is selected as a default for the first time you
are using the pump, or in case of a reset. At 1% the motor is
already running at 500 revolutions a minute, a lower value is
not possible.