AT-HDVS-150-TX / AT-HDVS-150-TX-PSK
17
Display Control
The AT-HDVS-150-RX features a control interface which can be used to program connected transmitters, allowing
them to power-on/off displays as well as adjust the appearance of the output image.
In order to configure display control, the control software should be downloaded and installed. The control software
is available for download, under the AT-HDVS-150-RX page on the Atlona web site, and supports programming of the
following transmitters.
Installing the Software
GND
RxD
TxD
1. Download the control software from the Atlona web site.
a. Go to http://atlona.com/product/at-hdvs-150-rx/.
b. Scroll down the page and locate the
Resources
tab.
c. Click on the
Control Software Version
hyperlink to begin downloading the software.
2.
Extract the files from the .zip file.
3. Double-click the setup.exe to run the installation wizard. Follow the directions on each screen to install the
software.
Supported Transmitters
AT-HDVS-150-TX
AT-HDVS-150-TX-WP
AT-HDVS-150-TX-WP-UK
IMPORTANT
: Note the folder/directory where the control software is being installed on the
computer. This information will be necessary, later. The default installation directory is \Program
Files (x86)\AT_HDVS_RX.
Connecting RS-232
1. Connect a serial cable from the
RS-232
port on the AT-HDVS-150-RX, to the RS-232 port on the display.
The included 3-pin captive screw connector should be wired as shown. If a DE-9 port is not available on the
computer, a DE-9 to USB cable may be used.
to display
HDBaseT IN
FW
DC 48V
+
HDMI OUT
AUDIO OUT
L
R
RX TX
RS-232
MENU
V
V
PW
LINK
NOTE:
DE-9 to USB cables usually require a driver. Refer to any documentation that was provided
with the cable to ensure correct functionality.
Solution Setup and Configuration Guide
