AT-HDVS-150-TX / AT-HDVS-150-TX-PSK
10
AT-HDVS-150-TX / AT-HDVS-150-TX-PSK
1.
Use HDMI cables to connect up to two HD sources to the HDMI 1 and HDMI 2 ports on the switcher.
2. Connect a VGA cable from a VGA source to the
VGA IN
port on the switcher.
3. Connect a 3.5 mm mini-stereo cable from the
AUDIO IN
port on the switcher to the analog audio source.
This port allows two-channel analog audio to be included when the VGA IN port is selected.
See Passing Analog
for more information.
4.
Connect an Ethernet cable, up to 230 feet (70 meters), from the
HDBaseT OUT
port on the switcher to
a PoE-compatible receiver (not included). Ethernet cables should use EIA/TIA-568B termination.
No power supply is required for the AT-HDVS-150-TX. This unit will be powered over the Ethernet cable, from an
HDBaseT receiver.
AT-HDVS-150-TX-PSK Only
5. Connect the included power supply to the
DC 48V
port. Connect the power supply if the HDBaseT receiver or
projector not a PoE-capable device
6. Connect the power supply to an available AC outlet.
IMPORTANT
: Using
EZ RJ-45 connectors are being used, make sure that each twisted pair does
not extend beyond the RJ-45 connector. Exposed twisted-pair wires may cause a short when
connected to the
HDBaseT OUT
port.
Installation
Connection Instructions
