Panduit Atlona AT-HDR-SW-52ED, Руководство пользователя

Страница: 12 / 81

AT-HDR-SW-52ED 12
Installation
IP Configuration
1. Make sure the AT-HDR-SW-52ED is powered.
2. Connect an Ethernet cable between the LAN port of the AT-HDR-SW-52ED and the Local Area Network (LAN).
3. Press and hold the POWER button for approximately 15 seconds. Release the POWER button once all the front-
panel LED indicators begin to flash. The number of flashes will indicate the currently selected IP mode. Refer to
the table, below.
POWER Button flashes Description Settings
Two Static IP mode IP address:
192.168.1.254
Subnet mask:
255.255.0.0
Gateway:
192.168.1.1
Four DHCP mode DHCP server assigned
The AT-HDR-SW-52ED is shipped with DHCP enabled. Once connected to a network, the DHCP server (if available),
will automatically assign an IP address to the unit. If the AT-HDR-SW-52ED is unable to detect a DHCP server within
15 seconds, then the unit will use a self-assigned IP address within the range of
169.254.xxx.xxx/16
. If this
occurs, refer to Automatic Private IP Addressing (APIPA) Mode (page 14) .
Use an IP scanner, along with the MAC address on the bottom of the unit, to identify the unit on the network. If a
static IP address is desired, the unit can be switched to static IP mode.
Using the Front Panel
NOTE: When switching between DHCP and static IP mode, the AT-HDR-SW-52ED will retain
the last assigned IP address until it is changed manually (static IP mode) or assigned a new IP
address by the DHCP server.
S/PDIF OUT
LAN FW DC 48V
+ -
1 2 3 4 5
HDMI IN HDMI OUT
L R
+ +
RX TX
RS-232
OUT
IR
IN
S S P
HDBaseT OUT
AUDIO
HDMI 1
HDMI 2
HDMI 3
HDMI 4
HDMI 5
VOLUME
AT-HDR-SW-52ED
POWER INPUT
POWER button