Panduit Atlona AT-HDR-SW-52ED, Руководство пользователя

Страница: 14 / 81

AT-HDR-SW-52ED 14
Installation
• Setting DHCP mode
1. Connect to the AT-HDR-SW-52ED using RS-232 or Telnet.
2. At the command line, execute the
IPDHCP
command using the on argument, as shown.
IPDHCP on
Once DHCP is enabled, the unit will be assigned an IP address by the DHCP server (if present).
Automatic Private IP Addressing (APIPA) Mode
If the AT-HDR-SW-52ED is unable to detect a DHCP server within 15 seconds, when set to DHCP mode, then
Automatic Private IP Addressing (APIPA) will be used to assign the an address within the IPv4 address block
169.254.xxx.xxx/16
. If a DHCP server is detected while in APIPA mode, then the AT-HDR-SW-52ED will be
assigned an address from the DHCP server pool. To manually adjust the IP address, connect an Ethernet cable
directly from the LAN port of the AT-HDR-SW-52ED to the LAN port of a computer, then do the following:
1. Click Start > Settings > Control Panel > Network and Sharing Center .
2. Click Change adapter settings .
3. Right-click on the adapter that is used to establish a wired connection to the network, and select Properties
from the context menu.
4. Under the Ethernet Properties dialog box, select Internet Protocol Version 4 and then click the Properties
button. Click the Use the following IP address radio button.
5. Enter the desired static IP address or the IP address provided by the network administrator. If the computer
does not require Internet access or if a statically-assigned IP address is being used, then an address within the
IPv4 address block 169.254.xxx.xxx/16 can be entered.
6. Set the subnet mask to
255.255.0.0
.
7. Click the OK button then close all Control Panel windows.
IMPORTANT: Before continuing, write down the current IP settings in order to restore them,
later. If Obtain an IP address automatically and Obtain DNS server automatically are
selected, then this step is not required.