Panduit Atlona AT-DISP-CTRL, Руководство по установке

Страница: 6 / 12

6
Installation Guide
AT-DISP-CTRL
IP Configuration
1. Make sure the AT-DISP-CTRL is powered
2. Press and hold the
IP MODE button, on the rear of the unit, for approximately five seconds.
The AT-DISP-CTRL is shipped with DHCP enabled. Once connected to a network, the DHCP
server (if available), will automatically assign an IP address to the unit. If the AT-DISP-CTRL
is unable to detect a DHCP server within 15 seconds, then the unit will use a self-assigned IP
address within the range of 169.254.xxx.xxx .
Use an IP scanner, along with the MAC address on the bottom of the unit, to identify the unit on
the network. If a static IP address is desired, the unit can be switched to static IP mode.
The default static IP address is 192.168.1.254 .
Switching the IP mode
IP MODE LED flashes Description
Two Factory Static IP mode (IP address set to 192.168.1.254 )
Four DHCP mode
3. Release the button once the LED indicator, next to the IP MODE button, begins to flash
green. The number of flashes will indicate the currently selected IP mode.
HDMI IN HDMI OUT SOURCE
POWER
AT-DISP-CTRL
AT-DISP-CTRL
LAN
RX
PoE
TX TX
RESET
IP MODE
RS-232 IR OUT DC 5V
FW
IP Mode button
To display the IP address of the AT-DISP-CTRL, on the connected display, press and release the
IP MODE button.
Displaying the IP Address